TM 9-4120-388-14
Removal.
c.
(1) Remove six screws and Iockwashers.
(2) Using pliers, pull shaft that holds reset toggles together and disconnect reset actuator arm.
(3) Remove circuit breaker and circuit breaker cover.
NOTE
See paragraph 4-48 for repairs on circuit breaker push-pull reset parts.
Installation.
d.
(1) Using pliers, pull shaft that holds reset toggles together on circuit breaker.
(2) Place actuator arm into position and reinsert reset toggle shaft.
(3) Install circuit breaker and circuit breaker cover with six screws and Iockwashers.
(4) Using tags and wiring diagram (Figure 4-16) connect leads with spade type terminals.
(5) Remove tags.
(6) Install junction box cover and tighten four captive panel fastener screws.
(7) Install junction box. (See para 4-46.)
