TM 9-4120-388-14
4-52. FUSES (F1 , F2 AND
F3).
b. Removal
This task consists of:
a. Inspection/Test
c. Installation
INITIAL SET-UP:
Equipment Condition
a. Inspection/Test.
(1) Inspect for cracks, corrosion, loose electrical connections, and loose mounting hardware. Repair and tight-
en loose electrical connections and tighten loose mounting hardware. Replace fuse block if it is cracked,
broken or badly corroded.
(2) If a fuse is suspected to be bad, pull it from the fuse block and look for broken or melted element.
b. Removal.
(1) Pull fuses.
(2) If fuse block is to be replaced, tag and remove wire leads.
(3) Remove two screws and lock nuts.
(4) Pull fuse block from box.
Installation.
c.
(1)
Place fuse block in box and align holes.
(2)
Secure fuse block to box with two screws and lock nuts.
(3)
See tags and wiring diagram (Figure 4-16) and connect leads. Remove tags.
(4)
Install junction box cover and lower front panel. (See para 4-47.)