TM9-4120-398-14
This task covers: R e p l a c e m e n t
INITIAL SETUP
Tools
Equipment Conditions
Tool kit, refrigeration SVC
Riveter, blind, hand
Power OFF
General Safety Instructions
Materials/Parts
Solvent (Item 15 Appendix E )
WARNING
Cleaning cloths (Item 12 Appendix E
Adhesive (Item 1 Appendix E)
Dry cleaning solvent (Federal Specification
PD-680) used to clean parts is
potentially dangerous to personnel and
property.
Do not usc near open flame or excessive heat.
Flash point of solvent is 100 F to 138 F
(38 C to 59 C).
Replacement
Adhesive mounted.
a.
WARNINGS
Dry cleaning solvent (Federal Specification PD-680) used to clean parts is potentially dangerous
to personnel and property. Do not use near open flame or excessive heat. Flash point of solvent is
100 F to 138F (38 C to 59 C).
(1) Using solvent (item 15 Appendix E) and a cleaning cloth (item 12 Appendix E), clean information plate and
mounting surface.
(2) Apply a thin coat of adhesive (item 1 Appendix E) to the information plate and mounting surface. Allow
adhesive to dry until tacky. Apply the information plate to mounting surface and press firmly to assure an even bond.
(3) Using solvent (item 15 Appendix E) and cleaning cloth (item 12 Appendix E), remove excess adhesive from
areas around the information plate, being careful not to allow solvent to flow undeneath the information plate.
(4-19 blank)/4-20
