TM9-4120-400-14
4-23.
REPLACEMENT
INSTALLATION
Insert switch (8) into control panel (11) and secure with nut (9) and washer (10).
1.
2.
See tags and wiring diagram (fig. 4-4) and connect wire leads. Remove tags.
3.
Check that grommets (12) are in place in shaft holes.
Slip back plate (7) in place and align holes in back plate with the three posts (6). Check that grommets (12) are
4.
still in place in shaft holes. Secure with three self-locking screws (5).
Install TEMPERATURE SELECTOR knob (4) and tighten setscrew (3).
5.
6.
Slip cover (2) in place and secure with four screws (1).
NOTE
FOLLOW-ON MAINTENANCE:
M O D E SELECTOR SWITCH
S1.
e. Installation
This task covers:
b. Inspection
c. Testing
d. Replacement
a. Removal
INITIAL SETUP
TooIS
Equipment Condition
Refrigeration Unit Service Tool Kit
Materials/Parts
Mode Selector Switch
Self-locking Screws (3)
4-66