TM 9-4120-401-14
4-17. CONDENSER END GUARD AND EMI SCREEN. - continued
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Do not use near open flame or excessive heat. Use in well
ventilated area.
b. Clean.
Wipe or brush the dirt from the guard and screen. If the item is extremely dirty, clean with a detergent
solution or dry cleaning solvent.
c. Replace.
Replace guard (3) or EMI screen (4) (EMP equipped units only) if badly dented or bent or if EMI screen is
torn.
d. lnstall.
(1) Position EMI screen (4) (EMP equipped units only) and guard (3) against unit and aline mounting holes.
Secure in place with 27 sets of screws (1) and lock washers (2).
(2) Install four snap fastener studs (5) into guard (3).
