TM 9-4120-401-14
5-26. ACTUATING CYLINDER.
c. Adjust
b. Replace
a. Inspect
This task covers:
INITIAL SETUP
Equipment Condition
Tools
Remove top panel (para 4-11).
Refrigeration Unit Service Tool Kit
Appendix B, item 1
Materials/Parts
Actuating Cylinder
a. Inspect.
Check actuating cylinder (1) for signs of damage and loose or missing hardware. Replace if damaged.
b. Replace.
(1) Remove refrigerant desiccant dehydrator. (See paragraph 5-22.)
(2) Disconnect flare nut fitting (2) from actuating cylinder (1).
(3) Remove two nuts (3), flat washers (4) and actuating cylinder (1). Be careful not to lose flat washer (5).
(4) Install new actuating cylinder (1), check that flat washer (5) is in place and attach two flat washers (4) and
nuts (3) (do not tighten).
