(2) Be sure latch hinge (1) is released then remove two screws (2), lock washers (3), latch hinge, and latch
hinge doubler (4) (front set only). Discard lock washers.
Figure 4-18. Latch Hinge and Latch Hinge Doubler.
(1) Install latch hinge doubler (4) (front set only) and latch hinge (1). Align mounting holes and secure with two
new lock washers (3) and screws (2).
4.20 END PANEL REPLACEMENT.
THIS TASK COVERS:
General Mechanics Tool Kit
Lock Washers (qty 10)
The FDECU cover is heavy. Be sure the cover retaining rod is in place and
properly secured with hair pin cotter. Injury can occur if cover drops.
(3) Pull quick release pin (1) if installed.
(5) Remove 10 screws (2), lock washers (3), flat washers (4), and end panel (5). Discard lock washers.