TM 9-4120-411-14
4.20 END PANEL REPLACEMENT - CONTINUED.
(6) Remove I.D. plate (6) and label (7) from old end panel (5) and install on new end panel. If label cannot be
removed and re-used, replace it with new one.
Figure 4-19. End Panel.
b. Installation. See figure 4-19.
(1) Be sure I.D. plate (6) and label (7) were installed onto new end panel (5). Install end panel and align
mounting holes. Secure with 10 flat washers (4), new lock washers (3), and screws (2).
(2) Install duct if necessary per paragraph 4.4.6.
(3) Insert quick release pin (1) if necessary.
(4) Lower and secure cover per paragraph 4.2.
(5) Connect FDECU to power source and operate per pa ragraph 2.4.
4.21 ACCESS PANEL REPLACEMENT.
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General Mechanics Tool Kit
Item 1, Section III, Appendix B
a. Removal. See figure 4-20.
(1) Shutdown the FDECU per paragraph 2.4.
(2) Turn to release six captive hardware fasteners (1) and remove access panel (2).
4-56
