e. Adjust the distributor speed to 2000
lowest points.
rpm. If lines now dance and shift, this in-
b. Check to see that the vacuum pump
dicates bouncing points at high speed due
switch (12, fig. 4), direction control switch
to weak breaker arm springs or friction
in breaker arm bearings.
are in their off position.
f. Turn the speed control fully clock-
wise, set the direction control switch in
the off position, remove the coil leads,
4) from the power source and the work
lamp lead from the 115-volt electrical re-
and snap the power switch off.
ceptacle.
d. Wrap the power cable, leads, and vac-
uum hose and stow them in the stowage
a. Check to see that the speed control
compartment.
(14, fig. 4) and cam angle adjustment (19,
