TM 5-2420-230-10
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch.
END OF TASK
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
References
Test Equipment
None
None
Equipment Conditions
Tools and Special Tools
TM or Para
Condition Description
Vehicle prepared for servicing (Do
not install FEL maintenance arm).
Drawings Required
None
Materials/Parts
Estimated Time to Complete
18 min.
Personnel Required
MOS 21J, Construction Engineer Operator
a. Removal.
(1)
Using Allen wrench, remove four screws (1) and
washers (2) securing collar to firewall cover (3) and
lift out of position.
(2)
Using ratchet/breaker bar and socket, remove
12 bolts (4).
(3)
Remove firewall cover (3).
b. Installation.
(1)
Using a clean rag, clean holes and surface of firewall
cover (3).
(2)
Install firewall cover (3), ensuring pilot holes are
aligned.
(3)
Using ratchet/breaker bar and socket, install
12 bolts (4). Tighten bolts.
(4)
Using Allen wrench, install four washers (2) and screws (1) securing collar to firewall cover (3). Tighten scews.
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch.
END OF TASK
Change 1