TM 5-2420-230-10
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
References
Test Equipment
None
None
Equipment Conditions
Tools and Special Tools
TM or Para
Condition Description
Hammer, BII, Item 10, Appendix B
Vehicle prepared for servicing (Do
Punch, BII, Item 20, Appendix B
not install FEL maintenance arm).
Materials/Parts
Drawings Required
Pin, retaining, backhoe bucket tooth, Item 19,
None
Tooth, backhoe bucket, Item 24, Appendix C
Estimated Time to Complete
6 min.
Personnel Required
MOS 21J, Construction Engineering Operator
a. Removal.
NOTE
Retaining pin must be driven out from outside of bucket.
(1)
Use hammer and punch to drive retaining
pin (1) out of tooth (2). Discard pin.
(2)
Remove tooth (2). Discard tooth.
b. Installation.
NOTE
When placing tooth on bucket, ensure that
it is oriented the same as other bucket teeth.
Retaining pin must be driven in from inside
of bucket.
(1)
Position new tooth (2) on bucket.
(2)
Use hammer to drive new retaining pin (1)
into tooth (2).
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch.
END OF TASK
Change 1
