TM 5-2420-230-10
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
References
Test Equipment
None
None
Equipment Conditions
Tools and Special Tools
TM or Para
Condition Description
Vehicle prepared for servicing (Do
not install FEL maintenance arm).
Materials/Parts
Drawings Required
Bushing, rubber, FEL 4-in-1 bucket tooth, Item 8,
None
Pin, retaining, FEL 4-in-1 bucket tooth, Item 20,
Estimated Time to Complete
6 min.
Personnel Required
MOS 21J, Construction Engineering Operator
a. Removal.
NOTE
Retaining pin must be driven out from outside of bucket.
(1)
Use hammer and punch to drive retaining
pin (1) out of tooth (2). Discard pin.
(2)
Remove tooth (2) and bushing (3). Discard
tooth and bushing.
b. Installation.
(1)
Position new bushing (3) in bucket.
(2)
Position new tooth (2) on bucket.
NOTE
Retaining pin must be driven in from inside
of bucket.
(3)
Use hammer to drive new retaining pin (1) into tooth (2).
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch.
END OF TASK
Change 1