TM 55-4920-384-13&P
104811C
AIR SHROUDING
To disassemble air shrouding, refer to Fig. 16. First
remove cylinderhead covers and the screws mounting
the flywheel shroud to the lower cylinder shrouds and
cylinder heat deflectors; then remove the screws hold-
in g the flywheel shroud to gear cover.
On power units, remove the front end panel as shown
71050C
in Fig. 17, together with flywheel shroud. Disassem-
ble rear end panel, as shown in Fig. 18, c o m p l e t e
with fuel tank. Balance of shrouding can now be
In reassembly, tighten the nuts for mounting the man-
readily removed.
ifolds, 40 to 50 foot pounds torque. Tightening beyond
specification may cause the flanges to break.
FUEL TANK
If a side mount gasoline tank is used, this should be
CYLINDER HEAD
The cylinder head must
be removed if it is necessary
to regrind valves, or to
do work on the piston, rings
or connecting rod. All
of the cylinder head screws
are plainly in view and
can be easily removed. Screws
The carburetor and manifold can be removed as a
D-17