TM 9-2330-227-148&P
CIRCUIT MARKER BAND REPLACEMENT - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE: Check operation of lights (page 2-22).
TASK ENDS HERE
CONNECTOR RECEPTACLE, 24-VOLT
This task covers:
a. Removal (page 4-74)
b. Installation (page 4-75)
INITIAL SETUP
Materials/Parts
Tools
Pliers, diagonal cutting
Connectors, electrical (eight required)
Tape, electrical (item 21, appendix E)
Tool, crimping
Wire stripper, hand
Personnel Required
Wrench, open-end, 7/16-inch
(two required)
One
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
NOTE
Tag wires to aid in installation (page 4-4). if circuit marker bands are missing or not
readable, replace (page 4-73).
Four screws (4)
1.
Cover assembly
Using two 7/16-inch open-end wrenches,
and nuts (5)
(1), connector
unscrew and take off.
receptacle (2),
and frame (3)
2.
Connector
Cover assembly (1)
Take off.
receptacle (2)
Eight wires (7)
3.
Connector
Using diagonal cutting pliers, cut
receptacle (2) and
where wires enter receptacle (2).
wire harness (6)
Frame (3)
Connector
Take off.
4.
receptacle (2)
4-74
