CONNECTOR RECEPTACLE, 24-VOLT - CONTINUED
INSTALLATION - CONTINUED
TASK ENDS HERE
CONNECTOR RECEPTACLE, 110-VOLT
This task covers:
INITIAL SETUP
Personnel Required
Tools
One
Screwdriver, flat-tip, 3/16-inch
Socket, 1/2-inch drive, 1/2-inch
ACTION
ITEM
LOCATION
REMARKS
WARNING
Contact with live 110-volt electrical wires could result in serious injury or death. Make
sure power source is disconnected before performing maintenance on the electrical
system.
REMOVAL
1. Connector
Four screws (2)
Using 1/2-inch socket and ratchet handle,
receptacle (1)
unscrew and take out.
and Iockwashers (3)
Pull away from wall just far enough to
2. Outside front
Connector
wall (4)
receptacle (1)
reach behind with 3/16-inch flat-tip
screwdriver.
NOTE
Tag wires to aid in installation (page 4-4). If circuit marker bands are missing or not
Two screws (5)
Using 3/16-inch flat-tip screwdriver,
3. Connector
receptacle (1)
unscrew part way.
4. Connector
Two wires (6)
a. Pull out wires (6).
recptacle (1) and
b. Take off receptacle (1).
wire harness (7)
4-76