TM 9-2330-227-14&P
WIRE CONNECTOR
This task covers:
a. Male Connector Repair (page 4-71)
c. Circuit Marker Band Replacement
b. Female Connector Repair (page 4-72)
INITIAL SETUP
Tools
Materials/Parts
Pliers, diagonal cutting
Band, marker (appendix G)
Screwdriver, flat-tip, 3/16-inch
Compound, Insulating (item 6, appendix E)
Tool, crimping
Contact (appendix G)
Tool, etching
Shell (appendix G)
Wire stripper, hand
Sleeve (appendix G)
Terminal (appendix G)
ACTION
LOCATION
ITEM
REMARKS
MALE CONNECTOR REPAIR
1. Wire lead (1)
Connector (2)
Separate halves.
2. Connector to be
Shell (3)
Slide wire lead (1) up until clear of con-
repaired
tact (4) and retaining washer (5).
Retaining washer (5)
3.
Take off.
4. Wire lead (1)
Shell (3)
Slide off over contact (4).
NOTE
If only replacing connector (2), skip steps 5, 6a, and 6c.
4-71
Change 1
