TM 9-2330-227-14&P
DOORS - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REMOVAL - CONTINUED
Two screws (3)
Using 3/16-inch flat-tip screwdriver,
6. Bottom bracket (1)
unscrew and take off.
and deck (2)
Bottom bracket (1)
Using pry bar, pry off.
7. Deck (2)
Weather-
Using putty knife, scrape off.
8. Van body (4)
stripping (5)
INSTALLATION
WARNING
Drycleaning solvent PD-680 is both toxic and flammable. Avoid prolonged breathing of
vapors, and avoid skin contact. Use only in well-ventilated area, and keep away from
open frame or excessive heat. Injury to personnel could occur.
Van body (4)
a.
Using PD-680 drycleaning solvent
9.
and brush, clean area for strip-
ping (5).
b. Wipe with rag, and let dry.
Weather-
a.
Put adhesive on van body (4) door
10. Van body (4)
stripping (5)
opening, and let dry until tacky.
b.
Put stripping (5) in place, and push
down until fully seated all around.
c.
Let dry.
Bottom bracket (1)
Using ball-peen hammer, tap in place,
11. Deck (2)
Two screws (3)
Screw in, and tighten using 3/16-inch
12. Bottom bracket (1)
flat-tip screwdriver.
and deck (2)
Two screws (6)
Screw in, and tighten using number two
13.
cross-tip screwdriver.
Top bracket (8)
Put in place.
14. Paneling (7)
Two screws (9)
Screw in, and tighten using number two
15. Top bracket (8)
cross-tip screwdriver.
and paneling (7)
Rear doors have four screws.
4-168
