TM 9-2330-247-14&P
4-35.
MASTER CYLINDER (Con't)
ACTION
ITEM
REMARKS
LOCATION
Twist off.
7.
Tube (1)
Hose (4)
Pull off.
8.
Clamp (2) and
screw (3)
9.
Tube (1) and
Nut (19) and
Using in. open-end box wrench and 1 in. open-end
wrench, unscrew nut (19) from filler cap (18).
filler cap (18)
master cylinder (5)
Tube (1)
10.
Take off.
Master cylinder (5)
Filler cap (18)
11.
Using 1 in. open-end wrench, unscrew and take off.
Master cylinder (5)
Using
in. flat-tip screwdriver, pry out.
12.
Gasket (17)
13.
Take off.
Master cylinder (5)
Boot (15) and
retaining clip (14)
INSTALLATION
Put on.
14.
Boot (15) and
retaining clip (14)
Put in position.
15.
Gasket (17)
Filler cap (18)
Using 1 in. open-end wrench, screw in and tighten.
16.
Tube (1)
Put in position.
17.
Tube (1) and
Nut (19) and
Using
in. open-end box wrench, screw nut (19)
18.
into filler cap (18) and tighten.
master cylinder
filler cap (18)
Hold tube (1) to stop it from turning.
(5)
Slide up around tube (1).
Tube (1)
19.
Clamp (2) and
screw (3)
Twist on.
20.
Hose (4)
a. Slide down clamp (2) until it fits over hose (4)
Tube (1) and
21.
Clamp (2) and
and tube end.
hose (4)
screw (3)
b. Using in. flat-tip screwdriver, tighten screw (3)
until clamp (2) is snug.
Do not overtighten or clamp (2) will cut
hose (4).
a. Using in. socket and ratchet handle with
in.
Straight adapter (10)
Master cylinder
22.
drive, screw in and tighten.
and washer (11 )
(5)
b. Take master cylinder (5) out of vise.
Put into position.
Airbrake chamber
Master cylinder (5)
23.
studs (16)
Screw and tighten using
in. socket, ratchet
Three
24.
handle with in. drive, and extension.
Iockwashers (13)
and nuts (12)
4-69
