TM 9-2330-285-14&P/TO 36A11-21-10-1
BLACKOUT STOPLIGHT REPLACEMENT
This task covers:
a. Removal (page 4-28)
b. Installation (page 4-28)
INITIAL SETUP
Tools
Flat-tip screwdriver
9/16-inch wrench
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
Two screws (2) and
1 Mounting bracket
Take out using a flat-tip screwdriver.
(1) to rear axle
two washers (3)
NOTE
If lamp is being removed as an equipment condition for other
lamp removals, omit steps 2 and 3 and set the assembly on top
of the axle with the wire intact.
2 Rear axle
Connector (4)
Pull the halves apart.
Screw (6) and
Take off using a 9/16-inch wrench.
3 Light assembly
washer (7)
(5) to mounting
bracket (1)
INSTALLATION
NOTE
If the lamp is being installed as follow-on maintenance for
other lamp installations, omit steps 4 and 5 and go directly
to step 6.
Put in using a 9/16-inch wrench.
Screw (6) and
4 Light assembly
washer (7)
(5) to mounting
bracket (1)
