TM 9-2330-285-14&P/TO 36A11-21-10-1
LIGHT ASSEMBLIES
This task covers:
e. Commercial stoplight installation
a.
Mounting bracket removal (page 4-30)
b.
Taillight removal (page 4-31)
f. Mounting bracket installation
c.
Commercial stoplight removal (page 4-31)
d.
Taillight installation (page 4-32)
INITIAL SETUP
Tools
Equipment Condition
Blackout stoplight removed
Flat-tip screwdriver
Cross-tip screwdriver
side only.)
ACTION
ITEM
REMARKS
LOCATION
MOUNTING BRACKET REMOVAL
NOTE
Make sure that the wiring on the rear axle and the light
assemblies are properly identified before separating wire
connectors.
Pull connectors (3) from clips (1) and (2)
1 Rear axle
Clips (1) and (2)
and four.
and separate.
connectors (3)
NOTE
The right side mounting bracket will only have three screws.
Four screws
Take out using flat-tip screwdriver. Take
2 Mounting bracket
(4) to rear axle
(5) and four
assembly from dolly.
washers (6)
