TM 9-2330-356-14
(a) While in motion, apply service brakes to
(h) Remove cover and gasket from the
ensure that brakes are working properly.
gasket and cover.
(b) Inspect marker lights, stop and turn
signal lights, blackout lights, and the control panel lights.
(i) Remove and clean automatic drain
Replace if faulty.
valve.
(5) All deficiencies which appear to involve
unsatisfactory design shall be reported on DA Form 2407
(3) Lubricate all points illustrated in lubrication
(DA Pam 738-750).
chart (fig. 3-1 through 3-6), regardless of interval.
d.
Correction of Deficiencies. Deficiencies disclosed
(4) Couple an authorized prime mover
during preliminary inspection and servicing or during the
(para 1-10) to
semitrailer. Perform a
"break-in" by
driving
"break-in" period shall be corrected by using organization
25-30 miles at speeds up to 30 miles per hour. Check the
or supporting maintenance activity. Deficiencies shall be
reported in accordance with DA Pam 738-750.
following:
Section II. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
Fabricated Tools and Equipment
Special Tools and Equipment
Special tools and equipment required for unit
Table 4-1 contains fabrication instructions for all tools
maintenance of the semitrailers are listed in TM
which must be fabricated by unit maintenance personnel
9-2330-356-24P. General mechanics tool sets and common
for maintenance of this unit. Tables 4-2 through 4-7 list
tool sets required for maintenance are authorized by the
bulk material and dimensions for fabrication of specific
Table of Allowance (TA) and the Table of Organization
electrical leads, harnesses and cables, tubes, conduits, and
and Equipment WOE).
chains.
Repair Parts
Repair parts authorized for use by unit maintenance are
listed and illustrated in TM 9-2330-356-24P.
Material Required
Reference No. or NSN
Nomenclature
1 EA
NSN 6685-00387-9854
Pressure gage
2 EA
Gladhand
MS35746-1
1 EA
Valve
11668037
1 EA
CPCXI, 120280
Tee
3 EA
Nipple
MS51846-42
2 EA
Bushing
MS51847-4
Fabrication Instructions:
Assemble parts to create gladhand connector as shown