TM 9-2330-356-14
(2) Installation.
CAUTION
(a) Tape together all loose wires on control
Be sure leads and jumpers are properly con-
nected.
panel end of new harness.
(f) Connect harness wires to control panel
(b) Coat entire harness with silicon or a mild
leads and jumper assemblies.
soap solution.
(g) Close control panel and install six round
head screws. Be sure tubing to gages is not folded or
(c) Attach new harness to cord that is in the
crimped.
conduit.
(h) Connect wiring harness to engine
(d) Pull wiring harness through conduit
using the cord until end of harness is in control panel box
c.
Replacement of Control Panel to Engine Junction
and leads are long enough to reach panel wiring leads and
Box Conduit.
jumper assemblies.
(1) Removal.
(e) Remove cord from end of harness and
(a) Remove control panel wiring harness
install new terminals to wires.
(step b).