TM 9-2330-356-14
TA099796
(f) Clean up all fuel spills.
(4) Filter/Separator Gage.
(5) FueI Pressure and/or Oil Pressure Gages.
NOTE
NOTE
Put suitable container under tube connec-
tions to catch fuel.
Put suitable container under tube connec-
tions to catch fuel.
(a) Disconnect lines from 90 tube elbows
(a) Disconnect line from tube fitting at rear
of gage.
(b) Remove lens and cover from front of
gage.
(b) Remove coupling securing gage to
bracket on control panel.
(c) Remove two screws, washers, and nuts
that secure gage to control panel.
(c) Remove gage and four washers through
front of control panel.
Remove gage. Remove both elbows
(d)
(d) Install new gage in reverse order of (a)
from gage.
through (c). Be sure to shim gage with existing washers.
Install gage in reverse order of steps (a)
(e)
(e) Clean up all fuel spills.
through (d).