TM 9-2330-356-14
(f) Position control valve between tubes
(e) Place the control valve assembly on a
clean surface and remove elbow (6) from the control valve.
95-105 lb.-ft.
(f) Remove coupling gaskets.
(g) Replace elbow (2) and connect copper
(g) Loosen fittings (7) and (8) and remove
tubing (3) between elbow (2) and fitting (1).
tube (9).
(h) Connect the five nylon tubes to the
(h) Unscrew nipple (10). Remove valve (11),
control valve at points A through E.
and elbows (7 and 12) as an assembly.
h.
(i) Unscrew nipple (13). Remove tee (14),
nipple (15), valve (16), tee (17), and hose fittings (8 and 18
through 20) as an assembly.
(1) Removal.
(j) Unscrew elbow (2) and drain valve (21).
(a) Loosen, but do not remove, two nuts
disconnect emergency valve cable.
(a) Remove drain plug from new control
valve, and install drain cock (12).
CAUTION
(b) Install items (8) and (13 through 20) onto
Support large outlet tube before removing
the control valve as an assembly.
coupling.
(c) Install items (7) and (10 through 12) onto
control valve as an assembly.
(b) Remove two nuts and bolts from
coupling and remove coupling. Slide gasket onto
(d) Replace line (9) and inserts (22) between
emergency valve.
fittings (7) and (8). Tighten fittings.
(e) Slide coupling gaskets over control valve
(c) Remove eight nuts from studs securing
tubes.
emergency valve to sump on tank.
TA502366