TM 9-2330-356-14
(2) Installation.
b.
Replacement of Adapter.
(a) Replace quick-disconnect fitting on new
(1) Remove six screws (4).
hose (M970 and M970A1 only).
(2) Remove adapter (5) and O-ring (6) by pulling
(b) Attach new hose to elbow of hose reel
adapter from the adapter plate (2).
and tighten.
(3) Install O-ring (6) in groove on adapter.
(c) Loosen hose reel lock and rewind hose
(4) Install adapter (5) into hole in adapter plate
and secure with six screws.
through 3-16 and 4-97).
c.
Replacing Dust Cap.
Replacement of 2-inch Hose (M970 and
b.
(1) Remove the dust cap (7) from the adapter (5).
M970A1).
(1) Removal.
(2) Release the spring clip at the adapter (5) and
remove cable and dust cap (7).
(a) Remove underwing nozzle from hose
(3) Attach spring clip to the adapter (5) and
install dust cap (7) on adapter.
turning hand wheel counterclockwise. Completely
Hose Reel Hoses and Fittings
unwind hose. Make sure end of hose is accessible for
removing hose.
a.
Replacement of 1-inch Hoses (M969 and
M969A1) and 1-inch Hose (M970 and M970A1).
WARNING
(1) Removal.
To avoid movement of hose reel by
accidental activation of hose real rewind
NOTE
switch, tighten hose reel lock.
On M969 and M969A1, remove nozzle and
bushing reducer.
(c) Lock hose reel in place by turning
handwheel clockwise until tight.
(a) Remove nozzle from end of hose
(d) Remove quick disconnect fitting from
outlet end of hose.
(e) Disassemble breakaway fitting into two
2-15) by turning hand wheel counterclockwise.
pieces. Unscrew 45 elbow from hose fitting.
Completely unwind hose. Make sure you can reach the
end of the hose.
(f) To disassemble further, remove
capscrews which secure the flange adapter (fig. 4-143) to
the hose reel outlet elbow. Remove elbow, breakaway
WARNING
fitting, and adapter assembly. Place assembly in vise and
remove adapter flange and elbow from the breakaway
To avoid movement of hose reel by
fitting.
accidental activation of hose reel rewind
(2) Installation.
switch, tighten hose reel lock.
(a) Replace quick-disconnect fitting on new
(c) Lock hose reel in place by turning hand
hose.
wheel clockwise until tight.
(b) Assemble breakaway fitting half and
(d) Unscrew hose fitting from elbow on hose
flange adapter.
reel.
(c) Replace O-ring in groove of flange
adapter and install assembly onto hose reel outlet elbow.
(e) Remove quick-disconnect fitting from
Secure with four capscrews.
other end of hose (M970 and M970A1 only).
