TM 9-2330-356-14
(8) Slide washer (8) up against bushing inside
(4) On M970, M970A1 only, loosen the U-bolt
upper leg, and install roll pin (2).
connection securing cable to cabinet door shut-off lever.
Remove cable.
(9) Coat grease (item 17, Appendix E) heavily on
pinion and bevel gear teeth.
(5) Pull cables through cable guides and remove
cables.
(10) Apply a continuous 1/8-inch diameter bead of
adhesive to inside of cover (1). Install cover (1) to upper
Installation.
b.
leg (5).
(1) Slide nut (3) over one end of the 120-inch
e.
cable. Insert end of cable into end of adjusting bolt (4) and
tighten nut onto adjusting bolt.
Removal.
(2) Thread cable through cable guide on cabinet
a.
and U-bolt connection on emergency valve.
(1) Remove nut (3) and loosen u-bolt
connections (9) securing cable(s) 10 valve operator A.
(3) Adjust cable (para 4-51).
Remove cables.
(4) Connect the 168-inch cable to U-bolt
(2) Loosen U-bolt connection securing cable to
connection on valve operator A.
emergency valve.
(5) Thread cable through cable guides and
(3) Loosen U-bolt securing control cable to
connect to emergency valve shut-off.
emergency valve shut-off on curbside of trailer and
remove cable.
(6) Adjust cable (para 4-51).
