TM 9-2330-356-14
1. Screw (8)
9. Screw (4)
17. Spring
25. Washer (2)
2. Nut (8)
10. Clip (2)
18. Nut
26. Thermopower unit
3. Shutter (2)
11. Lower rod
19. Lockwasher
27. Bracket
4. Bracket (2)
12. Pivot arm
20. Flatwasher
28. BOX
5. Bracket
13. Nut
21. Washer
29. Capscrew (2)
6. Bracket
14. Clip
22. Bearing
30. Capscrew (3)
7, Bearing (4)
15. Ball arm assembly
23. Bolt
31. Washer (3)
8. Washer (4)
16. Spring
24. Spring
TA1OO115
d.
Reassembly of Shutter Assembly.
(b) Mount bracket (5) to box (28) using
bearing (7), screw (9), and washer (8). Be careful not to
confuse bracket (5) with bracket (6). Connect ball arm
(1) Shutter Thermo Power Unit. Insert thermo
assembly (15) to bracket (5) and pivot arm (12), using clip
power unit in bracket (27, fig. 7-44). Place two washers
(14) and nut (13).
(25) over end of power unit. Compress spring (24) and
install between bracket (27) and washers (25).
(c) Mount bracket (6), along with bearing
(7), screw (9), and washer (8). Mount lower rod (11) to
bracket (6) and pivot arm (12) using clips (10).
(2) Brackets.
(a) Reassemble pivot arm (12) using bolt
(9), and washers (8).
(23), bearing (22), washer (21), flatwasher (20), lockwasher
(19), and nut (18). Connect springs (16 and 17) to pivot
(3) Shutters. Mount shutters using eight screws
arm.
(1) and nuts (2). Ensure that adequate clearance between
7-38
