TM 9-2330-357-14&P
4-30. WIRING HARNESS REPAIR (Con't).
c. FEMALE CONNECTOR REPAIR
1.
Slide shell (9) and sleeve (10) back and cut
terminal (11) from wire (8). Discard terminal.
2.
Remove sleeve (10) and shell (9) from wire
(8).
3.
Strip insulation off wire (8) equal to depth of
new terminal (11).
4.
Slide shell (9) and sleeve (10) on wire (8).
5.
Position new terminal (11) on wire (8) and
crimp wire.
6.
Slide sleeve (10) and shell (9) over terminal
(11).
d. CONNECTOR PLUG ASSEMBLY REPAIR
NOTE
Male and female inserts are replaced in the same way. This procedure covers male.
Insert replacement.
1.
Remove coupling nut (15) from grommet retaining nut (13).
2.
Remove grommet (16) from coupling nut (15). Cut insert (17) from wire (14). Discard insert.
3.
Remove grommet (16), coupling nut (15), and
grommet retaining nut (13) from cable (12).
4.
Strip insulation off wire (14) equal to depth of
new Insert (17).
5.
Thread cable (12) through grommet retaining
nut (13), coupling nut (15), and grommet (16).
6.
Position new insert (17) on wire (14) and
7.
Press grommet (16) into coupling nut (15)
until seated.
8.
Install coupling nut (15) on grommet retaining
nut (13).
TA706464
4-51
