TM 9-2330-357-14&P
5-12. OUTRIGGER DRIVE MOTOR THERMAL SWITCH REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
Tools/Test Equipment:
General mechanic's tool kit
One gasket
Field automotive shop set
References:
TB SIG 222
NOTE
This task only applies to outrigger drive motors produced by Westinghouse.
a.
REMOVAL
1.
Remove eight bolts (1) from rear cover (4).
2.
Remove rear cover (4) and gasket (3) from
outrigger drive motor housing (2). Scrape all
gasket material from both rear cover and
outrigger drive motor housing. Discard gasket.
3.
Mark outrigger drive motor housing (2) and end bell (9) to aid during installation.
4.
Cut lacing wire (7) from four brush hold-down screws (8). Discard lacing wire.
5.
Remove two screws (6), washers (5), and end bell (9) from outrigger drive motor housing (2).
5-50