TM 9-2330-371-14&P
BACKING PLATE - CONTINUED
INSTALLATION CONTINUED
NOTE
FOLLOW-ON MAINTENANCE:
1. Install wheel cylinder (page 4-75).
2. Adjust brakes (page 4-63).
3. Test brakes (page 2-18).
TASK ENDS HERE
HYDRAULIC TUBES AND FITTINGS
This task covers:
a. Removal (page 4-79)
b. Installation (page 4-81)
INITIAL SETUP
Materials/Parts Continued
Tools
Container, 1-quart
Tape, teflon (item 18, appendix E)
Wrench, 7/16-inch, open-end
Personnel Required
Wrench, 1/2-inch, open-end
Wrench, 9/16-inch, open-end
Wrench, 5/8-inch, open-end
One
Equipment Condition
Materials/Parts
Hydraulic fluid drained (page 4-72).
Rags, wiping (item 14, appendix E)
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
NOTE
Each axle has the same hydraulic tube and fitting
arrangement. This procedure is for one. Repeat
this procedure for the other.
When lines and fittings are being removed, some
hydraulic fluid will spill out. Use a container to
catch fluid as the lines and fittings are removed, and
shop rags to wipe up spillage.
If replacing the right hydraulic tube only, go to step 3.
If replacing left hydraulic tube only, go to step 8.
