TM 9-2330-371-14&P
BRAKESHOE ASSEMBLY REPAIR - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REPAIR
16 rivets (3)
Using drill motor and bit, drill out.
Brake lining (1)
1.
and brakeshoe (2)
Take off.
Brake lining (1)
Brakeshoe (2)
2.
Place brakeshoe (2) in bed of arbor
Bushing (4)
a.
3.
press.
Using brass drift, placed between
b.
bushing (4) and ram of press, drive
out.
c.
Get rid of bushing (4).
d.
Using wire brush and solvent, clean
brakeshoe (2).
Brakeshoe (2)
a.
Check for cracks, breaks in welds,
4.
distortion, warping, and rivet
holes (5).
If defective, replace.
b.
New bushing (4)
a.
Place brakeshoe (2), in bed of
Brakeshoe (2)
5.
arbor press.
b.
Start bushing (4) in anchor pin hole
of brakeshoe (2), and drive in
until flush with face of brakeshoe (2).
NOTE
If drums have been turned, a shim must be used
between brakeshoe and lining. Shim must be the
same thickness as the total depth of cut made when
turning the drum.
a. Line up holes.
New brake lining (1)
Brakeshoe (2)
6.
and shim (6)
b. Using brake reliner, put in rivets (3)
starting in center and working outward.
c. Using 0.0002-inch (0.0508-mm) feeler
gage, check fit. Gage should not
penetrate past rivets.