TM 9-2330-371-14&P
U-BOLTS, SADDLE, AND SPRING - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION CONTINUED
Position on top of spring assembly (2)
Spring saddle (1)
13.
making sure spring center bolt nut (3)
fits into recess hole of saddle (1).
Position over saddle (1) and down through
Two U-bolts (4)
14.
boltholes (5) in spring seat (6).
a. Slide washers (7) over U-bolts (4),
Four washers (7)
15.
and screw on hex nuts (8).
and hex nuts (8)
b. Using torque wrench and 1 7/16-inch
socket, tighten hex nuts (8) to 200-
320 ft-lb (271-434 NZm).
Using torque wrench, with torque multi-
Two spring seat
16.
plier, and 1 3/4-inch socket, tighten to
capscrews (9)
650-750 ft-lb (881-1017 NZm).
Remove hydraulic doily jack (10) and
blocks (11).
NOTE
FOLLOW-ON MAINTENANCE: Install bogie
TASK ENDS HERE
TA224331
5-28