TM 9-2330-381-14
4-116. STORAGE AND SHIPMENT MATERIALS (CONT)
Table 4-1. Storage and Shipment Materials - Continued
Item
Specification
Description
7
MIL-L-21260
Preservative oil, Grade PE 10-1
8
MIL-L-21260
Preservative oil, Grade 30
9
MIL-C-16173
Preservative, Grade 4
10
QQ-S-781
Strapping, steel and seals, Type I, Class I;
Finish A, 1-1/4 inch wide, 0.031 inch thick
11
QQ-S-781
Strapping, steel and seals, Type I, Class I,
Finish B, 3/4 inch wide, 0.035 inch thick
12
UU-T-81
Tag, shipping, paper, Type B, Size 6
13
PPP-T-60
Tape, packaging, waterproof, Type III, Class I.
or
MIL-T-22087
Tape, packaging, waterproof, Type II.
4-117. PREPARATION PROCEDURES
NOTE
These procedures apply to both Level A and Level B.
The semitrailer weldment and BII mounted on the semitrailer require very little
surface preparation since many of the surfaces are painted. However, due to
extensive use and handling, some paint chipping will occur, allowing rust and/or
corrosion to start. All BII and painted surfaces of the semitrailer must be
thoroughly cleaned to remove all rust and corrosion, and touch-up paint applied as
needed to restore surface protection.
a. Remove all rust and corrosion from semitrailer weldment surfaces and trailer-mounted BII, using a wire brush
(item 16, appx. B), crocus cloth (item 6, appx. E), and general purpose detergent (item 8, appx. E) and water.
b. Thoroughly wash semitrailer and allow to dry.
c.
Spot paint surface areas where paint has worn or chipped off.
d. Perform semiannual lubrication of entire semitrailer (para. 3-3).
e. Lower front and rear support legs (para. 2-22 and 2-23). Apply grease (item 12, appx. E) to all exposed bare
metal surfaces. Return all support legs to stowed position (para. 2-22 and 2-23).
4-530
