TM 9-2330-381-14
5-21.
HYDRAULIC CONTROL MODULE FRAME (CONT)
22.
Insert both sections of block clamp (28), retainer (27), stacking bolt (26), both sections of block clamp (25),
retainer (24), and capscrew (23) onto two hydraulic tubes (22 and 21).
23.
Install both sections of block clamp (33) and secure in place with capscrew (32).
24.
Insect sections of block clamp (20) onto two hydraulic tubes (22 and 21). Temporarily hold block clamp (20) in
place by loosely installing capscrew (19). Tighten both ends of two hydraulic tubes (22 and 21). Tighten
capscrews (19) to secure block clamps (20) in place.
25.
Remove caps/plugs installed and connect two hydraulic tubes (15 and 14) between two tube tees (17) on steering
manifold (18) and tube tees (16).
26.
Reconnect electrical connector (40) to electrical lead (41).
27.
Install rear cover (13) onto hydraulic control module frame (4) and secure with three screws (11) and lockwashers
(12).
28.
Install gooseneck isolation valve handle (5) through rear cover (13) and install shouldered pin (7) and cotter pin
(6).
29.
Aline gooseneck isolation valve handle (5) with clamp mount on hydraulic control module frame (4) and secure in
place by installing block clamp (10), spacer (9), and two screws (8).
30.
Using two people, install bottom cover assembly (3) into place on hydraulic control module frame (4) and secure
with six capscrews (1) and lockwashers (2).
FOLLOW-ON MAINTENANCE
1.
Open hydraulic tank shut-off valve (para. 2-6).
2.
Check and fill hydraulic tank as required (para. 4-17).
3.
Perform hydraulic system bleeding as required (para. 4-19).
4.
Operate hydraulic controls and check for leaks.
5-102
