TM 9-2330-383-14&P
4-13. WIRING HARNESS (CONT)
c. If wire leads have damaged insulation, tape over damaged insulation where
required. If wires within the harness loom are defective, replace wiring
harness.
d. Replace deteriorated grommets in frame holes.
INSTALLATION
CAUTION
Do not damage wiring or insulation during installation of wiring
harness.
a. Run wiring harness along frame and through grommets. Run harness over cross
beams. Install clamps over harness and secure.
b. Install tiewraps around composite light wires and to air lines along frame.
c. Position receptacle and cover on frame. Receptacle must have A contact
upward. Install capscrews and lock nuts. Be sure ground lead and lockwasher
are under one of the lock nuts.
d. Connect connectors to all lights.
e. Connect trailer to towing vehicle and check operation of all lights.
END OF TASK
Section VI. MAINTENANCE OF FRONT AXLE
4-14. KNUCKLE ASSEMBLY
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Personnel Required: 2
Welding machine
Equipment Condition
Welder tool kit
Bearing and bushing inserter tool
Wheels removed (para. 3-5)
Brake assemblies removed (para. 4-15)
Materials/Parts
Hub and drum removed (para. 4-26)
Brake air chamber removed (para. 4-20)
Cleaning compound (item 3, appendix E)
Camshaft assembly removed (para. 4-17)
Grease (item 7, appendix E)
Wiping rag (item 12, appendix E)
Cotter pin
Cotter pin
Bushing (2)
