TM 9-2330-386-14&P
Section VI. ELECTRICAL SYSTEM MAINTENANCE
Para
Para
Composite Light . . . . . . . . . . . . . . . . . . . 4-17
Wire Connectors . . . . . . . . . . . . . . . . . . . 4-22
Clearance Light . . . . . . . . . . . . . . . . . . . 4-18
12-volt Receptacle (Nose Plate) . . . 4-23
24-volt Receptacle . . . . . . . . . . . . . . . . 4-24
L i g h t Switch . . . . . . . . . . . . . . . . . . . . . . 4-25
Taillight . . . . . . . . . . . . . . . . . . . . . . . . . 4-20
Wiring Harnesses . . . . . . . . . . . . . . . . . . 4-21
Light Resistors . . . . . . . . . . . . . . . . . . . 4-26
4-17 COMPOSITE LIGHT.
d. Reassembly
This task covers:
a. Removal
e. Installation
b. Disassembly
c. Repair
INITIAL SETUP
Materials/Parts
T
o
o
l
s
Tie strap
No. 1 common tool kit
NOTE
If wire connectors are to be repaired or replaced go to
w i r e connector procedure (para. 4-22a).
Removal is not necessary for lamp or lens replacement.
I f circuit marker bands are missing or not readable, tag
wires or replace bands (para. 4-22d) before taking
e l e c t r i c a l connectors apart.
a. Removal.
WARNING
D i s c o n n e c t all electrical power before performing any
maintenance on the electrical system. Failure to do so
c o u l d result in injury.
( 1 ) If necessary, cut tie strap (1) and remove
f r o m wiring harness. Discard tie strap.
4-23
