TM 9-2330-386-14&P
4-47 SIDE PANELS (CONT).
WARNING
Eye protection is required. Particles from drilling
operations are hazardous to the eyes.
( 5 ) . Remove and discard blind rivets (5) and
(3)
Drill out four blind
rivets
rivet caps (6).
(4) Remove top rail (7) from plywood panel ( 8 ) .
R e p a i r i s l i m i t e d to replacement o f d e f e c t i v e p a r t s .
b. R e p a i r .
c.. Reassembly.
Position and center top r a i l ( 7 ) o n
(1)
p l y w o o d panel (8). Using holes in
top rail (7) as a guide, drill four
9/32-inch diameter holes through
plywood panel (8).
Insert four new rivet caps (6) in
(2)
top rail (7) and plywood panel (8).
Install four new blind rivets (5).
(3)
Center stake (4) on plywood panel
(4)
(8) and butt against top rail (7).
If necessary, drill seven equally
spaced pilot holes for screws (3).
Aline holes and install seven
(5)
screws (3).
Install pin (2) and screw (1) on
(6)
stake (4).
TASK ENDS HERE
4-48 MUD FLAPS.
This task covers removal and installation.
INITIAL SETUP
Tools
General mechanics tool kit
4-89
