TM 9-2330-388-14
2.
Disconnect
negative,
then
positive
battery
7-9.
Pump Removal and Installation, Food Grade
cables.
Mechanical Seal Replacement.
3.
Close emergency valve and open discharge
WARNING
valve to drain water from pump and water pipes.
Remove or disconnect battery
before
working on engine or pump set.
4.
Remove six screws securing rear panel to
cabinet.
Wash oil or fuel from skin as soon as
possible after contact.
5.
Disconnect skid from mounting plate by
removing four nuts and washers from bolts attaching
Never disconnect any wire unless the engine
assembly to engine.
Is stopped and all switches are in the "OFF"
position.
6.
Disconnect and remove coupler between "U"-
tube water outlet and pump inlet adapter.
1.
Disconnect upper red
regulator wire at voltage regulator.
7.
Remove two bolts and coupler that holds pump
outlet and disconnect outlet from pump.
Figure 7-18. Pump Disassembled
7-9