TM 9-2330-388-14
2.
Push flywheel assembly onto crankshaft and
7-6.
Ring Gear Removal and Installation
install key.
a.
Removal
3.
Install guard net, rope pulley, washer and
flywheel nut. Tighten flywheel nut to a torque of 275 NM
1.
Disconnect upper red
or 203 lb-ft.
regulator wire at voltage regulator.
4.
Position protective cover and secure with four
2.
Disconnect
negative,
then
positive
battery
Allen screws and flatwashers.
cables.
CAUTION
3.
Remove four Allen screws and flatwashers that
cure protective cover to engine front cover.
Do not connect red stator-to-regulator wire
until after battery has been connected to
4.
Remove flywheel nut and washer, rope pulley
engine.
and guard net.
5.
Connect positive then negative battery cables.
5.
Use puller NSN 5-180{)(023-1596, P/N 938 to
move ring gear. Fabricate legs as shown in Fig. NO
6.
Connect red upper stator to regulator wire.
TAG
7-7.
Compression Testing
6.
Remove flywheel using puller, fig.
Remove key from crankshaft.
If necessary to perform a compression check, utilize
Compression Tester \, NSN 10899180.
Figure 7-12. Removing Flywheel
7.
Remove flywheel ring gear with housing.
If
Figure 7-13. Compression Tester
necessary, remove ring gear.
b.
Installation
1.
Install ring gear on flywheel housing, if removed.
Secure flywheel to flywheel housing.
7-6