TM 9-2330-388-14
c. At completion of adjustment, unscrew
1.
Install valve cover, torque to 4.9 Nm or 3.6 lb-ft.
delivery connector of the injection pump, install the
Replace with new gasket if needed.
delivery needle valve in the injector pump and again stall
2.
Install air cleaner, washer and wing nut.
the connector.
CAUTION
CAUTION
Do not connect red stator-to-regulator wire
Do not connect red stator-to-regulator wire
until after battery has been connected to
until after battery has been connected to
engine.
engine.
3.
Connect positive then negative battery cables.
4.
Connect positive then negative battery cables.
4.
Connect red upper stator to regulator wire.
5.
Connect red upper stator to regulator wire.
7-5.
Starter Removal and Installation
7-4.
Adjusting Valve Clearance
a.
Removal of Valve Cover and Adjustment.
1.
Disconnect upper red
regulator wire at voltage regulator.
1.
Disconnect upper red
2.
Disconnect
negative,
then
positive
battery
regulator wire at voltage regulator.
cables.
2.
Disconnect negative, then positive battery cable
3.
Remove wing nut, washer and air cleaner.
3.
Remove wing nut, washer and air cleaner.
4.
4.
Remove two screws and washers from valve
5.
Remove two Allen screws holding starter to front
cover. Remove cover and gasket.
cover.
6.
Remove strap supporting starter at bracket and
remove starter.
b.
Installation
1.
Position starter to engine front cover and loosely
install two Allen Head mounting screws while supporting
starter.
2.
Torque starter-to-front-cover screws to 33 Nm
(25 ft-lbs).
3.
Tighten strap securing starter to support bracket.
4.
Figure 7-11. Adjusting Valve Clearance
5.
Install air cleaner and secure with washer and
5.
Adjust the valve clearance, with the engine cold
wing nut.
using a feeler gauge. Adjust the clearance between
valves and rocker arms to .008 in or .20 mm, fig. 7-11.
CAUTION
b.
Installation
Do not connect red stator-to-regulator wire
until after battery has been connected to
engine.
6.
Connect positive then negative battery cables.
7.
Connect red upper stator to regulator wire.
7-5