TM 9-2350-277-10
REMOVE/INSTALL T150 TRACK SHOE -- Continued
0093 01
INSTALLATION
WARNING
Loss of track end connector can cause track throw and loss of vehicle control. Soldiers can be
killed or injured. Mark end connector bolts. Notify unit maintenance to torque bolts.
NOTE
Position track shoes at slight angle to install end connectors on both shoe pins. Proper
tightening of end connector bolts keeps them from coming loose. Have unit maintenance
properly torque as soon as possible.
1.
Install new track shoe on track.
a.
Install two track pin alignment tools over track shoe pins. Install two track end connectors on track shoes. Remove
track pin alignment tools before driving end connectors flush with pin ends.
b.
Drive end connectors flush with pin ends and install bolts on each end connector.
c.
Tighten bolts using wrench handle extension with socket.
2.
Mark track that was replaced so bolts can be torqued later.
3.
4.
Stow spare track shoe
5.
Notify maintenance to torque bolts.
6.
All new, installed track shoes require a check between 30 to 80 miles of operation. END CONNECTOR BOLTS NEED
TO BE RETORQUED TO 400-430 LB-FT (543583 NM) TORQUE. Notify unit maintenance.
END OF TASK
Change 4