TM 9-2590-209-14&P
(1) Insert cable through moldboard rib.
(2) Position clamps approximately 2-inches
Position tube through hole in moldboard, and overlap
from ends of overlap, and space as shown.
cable end 14-1/2 inches.
Section II. REPAIR OF MAGNETIC CLUTCH
b. Install connector (10) and gasket (9) to clutch (8)
6-4.
and secure with four screws (12), lockwashers (11), and
lockwire (13).
6-5.
c. Install new key (5) in shaft (4).
6-6.
d. Slide clutch (8) on shaft (4).
remove ring (1).
e. Press bearing (6) on shaft (4) until it clears
retaining ring groove.
b. Remove snapring (2) from shaft (4).
f. Install snapring (7).
c. Using bearing puller, remove bearing (3) from
shaft (4).
g. Press bearing (3) into clutch (8).
d. Remove snapring (7) from shaft (4).
ring (1).
e. Using bearing puller, remove bearing (6) from
shaft (4).
i. Press assembled bearing (3) and clutch (8) on
shaft (4) until they clear retaining ring groove.
f. Using bearing puller, remove clutch (8) from
shaft (4).
j. Remove ring (1) from clutch (8).
g. Remove and discard key (5).
k. Install snapring (2) on shaft (4).
h. Remove lockwire (13), four screws (12), and
l. Using spanner wrench, install ring (1).
(9), to clutch (8).
6-10.
i. Remove connector (10), and' gasket (9) from
a. Connect positive lead of a 28 vde power supply
clutch (8) and discard gasket (9).
to pin in connector, and ground lead to rim of magnet
body half.
6-7.
instructions.
b. Turn power on and adjust for 26.530 vdc.
6-8.
Inspection. Check component parts for wear
a. Position connector (10), and new gasket (9), on
clutch (8).
6-2