TM 9-3431-254-14&P
277791C
Take out the following capscrews: 4 from flywheel
shroud to cylinder shrouds, 4 from heat deflectors
277788C
and 6 from inside flywheel shroud to gear cover. The
lined up accurately with the key. After mounting; seat
flywheel shroud, air cleaner and control panel assemb-
flywheel on crankshaft taper by slipping a piece of
ly can be removed as illustrated in Fig. B-31.
pipe over the end of the crankshaft and against the
in reassembly; insert rubber Bendix cover between
hub of the flywheel, and striking the end of the pipe
flywheel shroud and starter pad on gear cover.
a sharp blow with a hammer.
Disconnect ignition wires from field and armature
Remove cylinder head covers by dis-engaging 3 clips
terminals. Take out the capscrew holding the adjust-
and taking out the thumb screw.
ing strap to generator. By taking cut the 2 capscrews
Disconnect No. 2 and No. 4 spark plug wires and hi-
which hold the bracket to the engine supports, the
temperature switch wire. Slip wires thru grommet in
generator can be removed as shown in Fig. B-32.
shroud.
Note that the holes in the generator bracket are slot-
ted for belt alignment in reassembly.
Disconnect ignition wire at distributor and take off
distributor cap, leaving high tension cables in place.
Remove 2 capscrews holding the accessory drive
housing to the gear cover. As illustrated in Fig. B - 3 3 ,
the distributor and accessory drive housing can be
withdrawn from the gear cover as a complete-unit.
277790C
277799C
B-25
