TM 9-4110-255-14
NOTE
The following procedure applies to both inlet elbows. Quantities given are for each.
(3) Fuel Inlet Elbow.
(a) Cut tie down straps (13) as necessary and pull loom (14) back to expose clamp (15).
NOTE
It may be necessary to cut hose to remove it.
(b) Loosen clamp (15) and remove hose (16).
(c) Remove fuel tank per step b. below.
(d) Loosen nut (17) then remove connector (18) and tube ferrule (19). Discard nut, connector, and tube
ferrule.
(e) Remove fuel inlet elbow (20).
(f) Install new fuel inlet elbow (20).
(g) Install new nut (17) and new tube ferrule (19) onto new connector (18). Install connector into fuel
inlet elbow (20) and tighten nut to compress tube ferrule.
(h) Install fuel tank per step c. below.
(i) Slide clamp (15) over hose (16) end and install hose onto connector (18). Tighten clamp.
(j) Pull loom (14) over hose (16) end and secure using tie down straps (13) as necessary.
(4) Shut-Off Cock.
(a)
Drain fuel tank (21) (para 4-7).
(b)
Remove shut-off cock (22).
(c)
Install new shut-off cock (22).
(d)
Fill fuel tank (21) with appropriate type and quantity fuel (para 4-7).
b. Removal.
(1) Drain fuel tank (21) (para 4-7).
(2) Remove six screws (23) and carefully slide control box assembly (24) out as far as the strain relief bushing
(25) will allow.
(3) Tag wire leads (6) then remove two nuts (7) and wire leads.
(4) Cut tie down straps (13) as necessary and pull loom (14) back to expose clamps (15).
4-161
