TM 9-4110-255-14
4-67. FUEL TANK REPAIR AND REPLACEMENT . - Continued
NOTE
It may be necessary to cut hose to remove it.
(5)
Tag each hose (16) then loosen two clamps (15) and remove hos s.
e
(6)
Remove four bolts (26), lock washers (27), and two straps (28). Discard lock washers.
(7)
Carefully slide fuel tank (21) toward control box assembly (24) and remove through left side door.
(8)
Remove cap (1) and un-latch chain (2).
(9)
Remove six screws (3), lock washers (4), and fuel tank filler neck (5). Discard lock washers.
(10)
Remove five screws (10), lock washers (11), and fuel level sender (12). Discard lock washers.
NOTE
Connector, nut, and tube ferrule cannot be re-used. If removed, they must be replaced.
(11) Remove two fuel inlet elbows (20).
(12) Remove shut-off cock (22).
c. Installation.
(1) Install shut-off cock (22).
NOTE
Connector, nut, and tube ferrule cannot be re-used. If removed, they must be replaced.
(2)
Install two fuel inlet elbows (20).
(3)
Install fuel level sender (12), five new lock washers (11), and screws (10).
(4)
Install fuel tank filler neck (5), six new lock washers (4), and screws (3).
(5)
Latch chain (2) in place and install cap (1).
(6)
Slide tank (21) into position.
(7)
Install two straps (28), four new lock washers (27), and bolts (26).
(8)
Slide one clamp (15) over each hose (16) end and using tags, install each hose onto appropriate connector
(18). Tighten clamps.
(9) Pull loom (14) over each hose (16) end and secure using tie down straps (13) as necessary.
4-162
