TM 9-4110-258-13
CHAPTER 4
UNIT MAINTENANCE INSTRUCTIONS
SECTION I LUBRICATION INSTRUCTIONS
4.1
LUBRICATION.
Lubrication instructions are contained in Section III, unit level PMCS table 4-1.
SECTION II REPAIR PARTS, TOOLS, SPECIALTOOLS, TEST, MEASUREMENT,
AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT
4.2
COMMON TOOLS AND EOUIPMENT.
4.2.1 For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE),
CTA 50-970, or CTA 8-100, as applicable to your unit.
4.2.2 The Shop Equipment (1), Automotive Vehicle (SC 4910-95-CL-A74) will be used for all maintenance tasks. Any
additional tools required for an individual maintenance task will be identified in the setup information for
that task.
4.3
SPECIAL TOOLS. TMDE. AND SUPPORT EOUIPMENT.
4.3.1 The Repair Parts and Special Tools List (RPSTL) (TM 9-4110-258-23P) as well as the Maintenance Allocation
Chart (MAC) (appendix B) identify any tools and support equipment needed to maintain the refrigeration unit.
4.3.2 There are no special or fabricated tools required to maintain the refrigeration unit.
4.4
REPAIR PARTS.
4.4.1 Any mandatory replacement parts needed for the maintenance tasks are identified in the mandatory replacement
parts list located in Appendix G.
4.4.2 Repair parts are listed and illustrated in the repair parts and special tools list (TM 9-4110-258-23P) covering unit
maintenance for this equipment.
SECTION III SERVICE UPON RECEIPT
4.5
SITE AND SHELTER REQUIREMENTS.
4.5.1 The refrigeration unit requires a source of 200-230 Vac, and 50/60 Hz.
4.5.2 The refrigerator enclosure must have an accessible wall area of a minimum of 46 inches high and 50 inches wide.
4.5.3 The refrigeration unit weighs 1,000 lbs.
4-1
