TM 9-4110-258-13
4.6
SERVICE UPON RECEIPT OF MATERIAL.
4.6.1 Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage on SF 364, Report of Discrepancy.
4.6.2 Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750 as applicable.
4.7
INSTALLATION INSTRUCTIONS.
4.7.1 Tools and Equipment. Tools required -to install the refrigeration unit include a wrench for tightening-the mounting
hardware, lifting sling(s) (with hooks), spreader-bar (if needed), and hoist or similar lifting device.
4.7.2 Refrigerator Enclosure Preparation. The refrigerator enclosure must have an opening 36.00 inches (91.4 cm) wide
and 27.00 inches (68.6 cm) high and four 0.88 inch (2.24 cm) mounting holes (fig. 4-1). If an opening does not already
exist in the enclosure, see the enclosure manual for information on making such an opening.
Figure 4-1. Wall Opening Dimensions
4-2
