TM 9-4120-370-14
TO 35E9-229-1
4-7.
REMOTE MOUNTING OF CONTROL PANEL - Continued
l.
Uslng wrenches, remove four bolts and nuts and remove control panel from air conditioner.
m. Very carefully, coil capillary line and mount sensing bulb in loop clamp provided on back of control panel.
The control panel is provided with three sets of four holes. These holes are sized for use with 0.25 inch (0.64
n.
cm) diameter hardware. The control panel can be mounted using the top, bottom, or rear face holes.
o.
Care should be taken to locate the control panel and sensing bulb where there will be an accurate temperature
indication.
NOTE
Do not locate control panel on thin outside walls or near heat producing equipment or
lights.
p. Secure the control panel using appropriate hardware in the remote location.
Using screwdriver and wrench, install block-off panel using the four mounting screws and nuts removed from
q.
the control panel.