TM 9-4120-370-14
TO 35E9-229-1
NOTE
if relay socket was not removed, skip steps (1), (2), and (3).
(1) See tags and wiring diagram (Figure 4-20) and connect leads to relay socket.
(2) Clip relay hold down springs onto relay socket.
(3) Using screwdriver and wrench, secure relay socket and hold down springs with two screws and nuts.
(4) Aline relay and socket contacts and push relay firmly into socket and hold down springs.
Check that relay hold down springs dip into slots on relay.
Install junction box cover and lower front panel. (See para 4-46.)
Follow-on procedure:
4-53. HEATER RELAY (K1)
Remove junction box. (See para 4-45.)
Figure 4-73. Heater Relay (K1)
Removal
(1) Using a screwdriver, remove ten screws and lock washers from junction box cover.
(2) Remove cover.
(3) Tag and disconnect wire leads.
(4) Using screwdriver, remove four screws from relay.
(5) Remove U type spring nuts from relay.
(6) Remove relay.
b. Inspection
4-104
