TM 9-4120-370-14
TO 35E9-229-1
5-27. LIQUID QUENCH EXPANSION VALVE - Continued.
(8) Leak test all newly connected joints and those in the repaired area. (See para 5-10.)
(9) Evacuate and charge the refrigerant system. (See para 5-11 and para 5-12.)
Follow-on procedure:
Install lower front panel. (See para 425.)
5-28. RECEIVER
Preliminary procedure:
Remove junction box. (See para 4-45.)
Figure 536. Receiver
a.
Inspection
(1) Check for general condition and signs of leakage, If leakage is suspected, leak test per paragraph 5-10.
(2) Check that mounting hardware is secure.
b . Removal
(1) Discharge the refrigeration system in accordance with paragraph 5-7.
(2) Using screwdriver, remove two screws, flat washers, nuts, and clamps from receiver.
(3) Purge the system with nitrogen and debraze the tube connections. (See para 5-8 and para 5-9.)
(4) Remove the receiver.
Installation
c.
(1) Place the receiver on the tube ends, purge the system with nitrogen, and braze the tube joints. (See para
(2) Using a screwdriver and wrench, secure the receiver to the side panel with two screws, flat washers, nuts,
and clamps.
(3) Replace the dehydrator. (See para 5-14.)
(4) Leak test all newly connected joints and those in the repair area. (See para 5-10.)
(5) Install the junction box. (See para 4-45.)
(6) Evacuate and charge the refrigerant system, (See para 5-11 and para 5-12.)
